|
|
 |
 |
Tube Pulling Power Pack - Specifications |
|
Sizes Available |
3/8" O.D. TO 4" O. D. |
Models Available |
TPP - 50, TPP-75, TPP-30, PPP-50(Pneumatic) |
Hydraulic Tube Pulling Guns -Specifications |
|
Sizes Available |
3/8" O.D. TO 4" O. D. |
Models Available |
HPG-15, HPG-30, HPG-45 |
|
|
Push Type Internal Tube Cutter - ATP Series |

|
|
|
Internal Tube Cutter - PR68 Series |

|
Features : |
- PR-68 tube cutters are ideal for cutting thick walled boiler tubes of 2” O.D. and higher.
-
The Internal Tube Cutter PR-68 is driven via the square in a clockwise direction using either an electric, pneumatic or hydraulic driving machine.
-
PR-68 type tube cutters are available in standard reach of 4” (100mm). Additional reaches in increments of 4” are available up to 16” (400mm).
|
|
|
Tube Plugs |

|
Sizes Available |
3/8" O.D. TO 1 1/2" O.D. |
Models Available |
PLG-375-1 TO PLG-1500-1 |
|
|
One Revolution Internal Tube Cutter - OTC Series |

|
Features : |
- POWERMASTER “One Revolution” Internal Tube Cutter pierces and cuts off non-ferrous and thin walled ferrous tubes in one revolution.
- This “One Revolution” Internal Tube Cutter is designed for hand operation using a ratchet handle.
- The Cutter Tool Bit operates on an eccentric principle. The Tube Cutter is entered in the tube with the Tool Bit in c lo se d position , ratchet is applied and turned in clockwise direction. The Tool Bit contacts the tube during the One Revolution and pierces the tube wall and as turning is continued the Tool Bit shears through the tube along its circumference. This Cutter is fitted with an adjustable collar enabling it to reach into tubes at various distances and they are available in optional increments of 2”(50.8mm). Standard adjustable reach is 6”(152.4mm). ”A” reach = 8”(203.2). “B” reach = 10”(254.0mm). “C” reach = 12”(304.8mm) etc.
- All Cutters are available for MM tube sizes also.
|
Sizes Available |
5/8" O.D. TO 2 1/2" O.D. |
Models Available |
OTC-625-14 OT OTC-2500-18 |
|
|
Manual Tube Puller |

|
Features : |
- No power needed: Manual insertion and removal of tube with a hand wrench. Ideal for field service applications.
- Simple Design : Only two major parts reduce inventory.
- Ease of use : Hex at back of spear allows tightening without disassembly of thrust mechanism.
- Range of Sizes : A wide range of sizes allows use on popular tube size. Clarity of markings: Both spear and thrust collar are clearly marked for fast relating tool to job.
|
Sizes Available |
1/4" O.D. TO 1" O.D. |
Sizes Available |
MTP-25-18 TO MTP-100-20 |
|
|